Accord xpc installation manual

The Accord xpC enclosure is supplied without a Tamper Actuator in place. The panel will not function without a Tamper, it is therefore, the installer’s responsibility to correctly attach the Tamper Actuator. The Tamper Actuator consists of a spring, which is supplied in the Accord xpC Installation Kit, and one of the Knockout Tamper. Page Section 2:Installing The Accord Xpc. Installing the Accord Ancillaries Pack The Accord xpC control panel comes with an ancillaries pack. It contains ten zone links, a cable clamp (with two self tapping screws), two M4×20 mm lid screws, battery connector leads and 16 1K resistors. Changing Codes [8] The system can support up to 8 separate user codes. MASTER CODE:User 1. The Master Code (User 1) can be changed: 1. Enter Master Code (e.g. ).

The GP/GPc, XP/XPc and XR Series Fans can provide coverage up to + sq. ft. per slab penetration. This will primarily depend on the sub-slab material in any particular installation. In general, the tighter the material, the smaller the area covered per penetration. Appropriate selection of the GP/GPc, XP/XPc and XR Series Fan best. block off. Install where the damper had been located. Step 6 - Remove the four (4) 5/16 inch sheet metal screws from the discharge end of the unit that holds the blowers. Step 7 - Remove the four (4) plastic plugs from the desired discharge location and reinstall the plastic plugs in the holes where the bolts were removed from in Step 6. Alarm System User Manuals Downloads If you have lost or misplaced your alarm system's user manual then don't worry, simply click on the appropriate link below to download the specific manual for your alarm system.

Ademco Microtech Accord Xpc Installation Manual ; Ademco Microtech Accord Xpc Installation Manual; View and Download ADEMCO Accord user instructions online. Accord Security System. Ademco: Ademco Microtech Accord Xpc Manual. I have what I think is. Nov 6, - ademco xpc installation manual pdf. The time and date can also be set using. Page Section 2:Installing The Accord Xpc. Installing the Accord Ancillaries Pack The Accord xpC control panel comes with an ancillaries pack. It contains ten zone links, a cable clamp (with two self tapping screws), two M4×20 mm lid screws, battery connector leads and 16 1K resistors. ADT ACCORD XPC Security System: Frequently-viewed manuals. Eaton Crouse-Hinds Series Instruction Manual Instruction manual (13 pages) FBI XL-1T Installation And Setup Manual Installation and setup manual (72 pages) ADEMCO VISTAPS Series Installation And Setup Manual Installation and setup manual (96 pages) Honeywell LYNX Touch L Series Quick Installation Manual Quick installation manual (2 pages).